Vonyx ST110 Manuel D'instructions page 5

OPERATION INSTRUCTIONS
External AC
Plug one end of the AC cord provided into the AC input jack (1) on rear side of the amplifier. Then plug the other
end of AC cord into AC power outlet. Turn on the unit using the main power switch.
External DC
This unit can be powered also using external 12V DC power. Connect external 12V DC power to DC input jack on
rear side of the amplifier. Observe the correct polarity!
Rechargeable Battery
This unit can be powered internally using the built-in rechargeable battery. When AC power is connected,
CHARGE LED indicator will light red. The rechargeable battery is being charged. If FULL LED indicator light green,
the battery is fully charged and ready to power the unit alone.
Shut off the power switch and disconnect the AC power. Turn the unit back "ON" and the rechargeable battery will
power the unit alone.
Note: Turning off the unit power switch will allow the battery to be charged more quickly.
ATTENTION:
Before the device the first time is actuated, please charge the battery at least 12 hours and max. 72 hours!
Battery should be regularly charged. For optimal battery life the battery should be charged at least 1x per
month.
Please note that if you do not load within 6 weeks, the battery becomes defective !!
Warning!
This device is equipped with a class 1 laser diode. To ensure a safe operation do not remove any covers or
attempt to access the inside of the product. There are no serviceable parts inside the device. Maintenance and
service operations are only to be carried out by authorized dealers.
5