SW-Stahl 32230L Mode D'emploi page 12

E . D I O D E T E S T
1.
Connect the red test lead to "V.Ω.mA" jack and the black test lead to the "COM" jack
(The polarity of red lead is positive "+".).
2.
Set the rotary switch at " " position.
3.
Connect the red test lead to the anode of the diode to be tested and the black test
lead to the cathode of the diode.
4.
The approx. forward voltage drop of the diode will be displayed. If the connection is reversed,
only fi gure "1" will be shown.
B AT T E RY A N D F U S E R E P L AC E M E N T
If " "appears on display, it indicates that the battery should be replaced.
Fuse rarely need replacement and blow almost always as a result of operator's error.
To replace battery and fuse (FH 500mA/500V 10A/500V) remove the 2 screws in the bottom of the
case. Simply remove the old, and replace with a new one. Be careful to observe battery polarity.
I N F O R M AT I O N F O R P R I VAT E E N D U S E R
The Electrical and Electronic Equipment Act (ElektroG) contains a large number
of requirements for the handling of electrical and electronic equipment. The most
important ones are summarised here.
1. SEPARATE COLLECTION OF OLD DEVICES:
Electrical and electronic equipment that has become waste is referred to as old devices. Owners of old
devices must dispose of them separately from unsorted municipal waste. In particular, old devices do
not belong in household waste, but in special collection and return systems.
2. BATTERIES AND ACCUMULATORS AND LAMPS:
As a rule, owners of old devices must separate batteries and accumulators that are not enclosed in the
old device, as well as lamps that can be removed from the old device without causing damage, from
the old device before handing them in a collection point. This does not apply if old device is prepared
for reuse with the involvement of a public waste management authority.
3. OPTIONS FOR RETURNING OLD DEVICES:
Owners of old devices from private households can return them free of charge to the collection points
of the public waste management authorities or to the take-back points set up by manufacturers or
distributors as defi ned by the ElektroG.
4. MEANING OF THE SYMBOL „CROSSED-OUT DUSTBIN":
The symbol of a crossed-out dustbin shown on electrical and electronic equipment indicates that the
respective device is to be collected separately from unsorted municipal waste at the end of its service
life.
THE FOLLOWING BATTERIES OR ACCUMULATORS ARE CONTAINED IN THIS ELECTRICAL DEVICE:
Battery type: 9V battery
Chemical system: Alkali-manganese
INFORMATION ON HOW TO REMOVE THE BATTERIES OR ACCUMULATORS SAFELY:
- Warning: Make sure that the battery is completely empty.
- Carefully remove the battery or accumulator.
- The battery or accumulator and the device can now be disposed of separately.
12