Safety Instructions; Discription And Reference Guide; Front And Back Description - koban KMIR-01 Mode D'emploi

KMIR-01

2.2. Safety Instructions

This meter has been designed for safe use, but must be operated with caution.
The rules listed below must be carefully followed for safe operation.
• NEVER apply voltage or current to the meter that exceeds the specified maximum:
Input Protection Limits
Function
V DC, V AC
Frequency,Resistance, Capacitance Duty
Cycle,DiodeTest,Continuity
Surge Protection: 6kV peak per IEC 61010
• USE EXTREME CAUTION when working with high voltages.
• DO NOT measure voltage if the voltage on the "COM" input jack exceeds 1000V above
earth ground.
• NEVER connect the meter leads across a voltage source while the function switch is in
the current, resistance, or diode mode. Doing so can damage the meter.
• ALWAYS discharge filter capacitors in power supplies and disconnect the power when
making resistance or diode tests.
• ALWAYS turn off the power and disconnect the test leads before opening the covers to
replace the fuse or batteries.
• NEVER operate the meter unless the back cover and the battery and fuse covers are in
place and fastened securely.
If the equipment is used in a manner not specified by the manufacturer, the protection
provided by the equipment may be impaired.
6
EN
Maximum Input
600VDC/AC RMS
600VDC/AC rms
EN

3.Discription and reference guide

3.3.1.Front and back descriptions
1. LCD Display
2. MODE/RANGE button
3. Thermal mode/Light button
4. Navigation/Menu buttons
5. Rotary function switch
6. Positive(+) Probe input jack for A (Current).
7. Positive(+) Probe input jack for all
Inputs except A and mA
8. COM(-) Probe input jack
9. Thermal imager Len
10. Len cover
11. Probe slot
12. Support plate
13. Work light
14. USB interface cover lock
9
10
11
12
KMIR-01
1
2
3
4
5
6 7
8
13
14
7