Booster Light Patterns - weBoost DRIVE REACH Guide D'installation

______

Booster Light Patterns

Solid Green
This indicates that your booster is functioning properly and there are no issues
with installation.
Blinking Red, Then Solid Green
This indicates that one or more of the booster bands has reduced power due
to a minor feedback loop condition called oscillation. This is a built in safety
feature to prevent harmful interference with a nearby cell tower. If you are already
experiencing the desired signal boost, then no further adjustments are necessary.
If you are not experiencing the desired boost in coverage then refer to the
troubleshooting section.
Solid Red
This is due to a major oscillation (feedback) loop. This is a built in safety feature
that causes a band to shut off to prevent harmful interference with a nearby cell
tower. Refer to Troubleshooting section.
Light Off
If the Drive Reach signal booster's light is off, verify your power supply has power.
NOTE: The signal booster can be reset by disconnecting and reconnecting
the power supply.
After troubleshooting you must initiate a new power cycle by disconnecting and
then reconnecting power to the booster.
weboost.ca 866.294.1660
NEED HELP?
8
VEHICLE SIGNAL BOOSTER DRIVE REACH