If, on the other hand, a large amount of
hair and carpet fluff which typically
contains a lot of air is vacuumed up, the
indicator may fail to react even though
the bag is full. You should still change
it. Both these extremes can occur.
How to replace the dustbag (dia. 28 +
29)
^ Lift the release catch for the dust
compartment lid and raise the lid as
far as it will go (dia. 11).
The dustbag has a closing flap which
closes automatically when the dust
compartment lid is raised to prevent
any dust escaping.
^ Pull the dustbag out by the grip on
the collar.
^ Fit the new dustbag into the holder as
far as it will go. Leave it folded up
when you take it out of the box.
^ It should be unfolded as far as
possible in the dust compartment.
^ Close the dust compartment lid
securely, making sure it clicks into
position. Take care not to trap the
dustbag when doing so.
The lid will not close without a
dustbag in place. Do not force it!
When to change the dust
compartment filter (for motor
protection)
Replace this filter every time you start a
new packet of dustbags. A dust
compartment filter is supplied with
every packet of Miele dustbags.
All manuals and user guides at all-guides.com
How to change the dust
compartment filter (dia. 30)
^ Open the dust compartment lid.
^ Pull the dustbag out by the grip on
^ Lift up the filter frame until it clicks
^ Replace with a new dust
^ Close the filter frame.
^ Fit the dustbag into the holder as far
^ Close the dust compartment lid
When to replace the exhaust filter
Depending on model, your vacuum
cleaner will be fitted as standard with one
of the following exhaust filters (dia. 10):
a AirClean
Replace this filter every time you start a
new packet of Miele dustbags. An
AirClean exhaust filter is supplied with
every packet of Miele dustbags.
b Active AirClean 50 (black)
c HEPA AirClean 50 (white)
Replace if the display for the exhaust
filter change indicator is completely
filled with red (dia. 15).
This occurs after approx. 50 hours of
operation which is equivalent to about a
year of average use. The vacuum
cleaner can still be used. However, the
suction power will be reduced as will
the effectiveness of the filter if it is not
replaced in good time.
the collar.
and remove the old filter. Hold by the
clean, unsoiled section to remove it.
compartment filter.
as it will go.
securely, making sure it clicks into
position. Take care not to trap the
dustbag when doing so.
en
37