Trevi 106 Instructions D'assemblage page 9

8
VINYL LINER INSTALLATION (continued)
Fill the pool up to the base of the wall before stopping and
removing the vacuum cleaner.
PUMP RETURN FITTING
After you remove the vacuum cleaner, you may install the
return fitting. Place the return fitting ring against the liner
and adjust it so that it is perfectly aligned with the hole in
the wall. When the ring is properly positioned and
secured, cut the liner in the middle of the ring.
9
Place top seat on top joiner plates and secure each sec-
tion using four (4) metal screws. Attach the end of each
top seat section to the surface of the top joiner plates.
TREVI 106 / 186 / 206 MODELS
10
Hook the seat cap on the inside edge of the seat.
Screw the bottom seat cap into the upright using two (2)
metal screws.
Secure the two part of the seat cap with one (1) metal
screws and install the screw cap.
TREVI 106 / 186 / 206 MODELS
11
Position the safety procedures panel on the outside of the
pool. This panel must be at the most visible place from the
yard on your pool.
12
Note: See "Safety Information" manual page 1.
As described in the manual, all components of the filtra-
tion system should be placed to prevent a child to climb
on top and get access to the pool.
Using a little bit of stone dust (or sand), place at level a
patio stone 61cm x 76 cm (24" x 30") before installing the
motor and filter.
Position the motor on the stone and insert the two nozzles
to connect the hoses.
Then, install the filter tank. Adjust the lateral assembly
properly in its channel.
It is sometimes necessary to install the laterals.
Patch the center hole of the lateral assembly using the
plug to allow filtering sand to flow into the tank.
Remove plug. Install joint in cavity and secure filter head
by placing back wash position on side opposite to the
pool.
All manuals and user guides at all-guides.com
TOP SEAT INSTALLATION
SEAT CAP INSTALLATION
SECURITY SIGNS INSTALLATION
FILTRATION SYSTEM ASSEMBLY
Insert the return fitting from the inside, placing the first
gasket between the return fitting and the liner and the sec-
ond between the wall and the liner. Then tighten the out-
side ring with large pliers, taking care not to crease the
liner.
BOTTOM DRAIN (optional)
Find the holes through the middle of the liner and screw
the ring and gasket in against the liner before cutting the
liner in the middle of the ring, then screw on the drain
cover.
For the 217 and 218 models, align the top seat with the
guiding line on the joiner plate according to the pool size.
TREVI 217/ 218 MODELS
TREVI 217/ 218 MODELS
Screw the bottom foot cap with two (2) metal screws in
the free holes for models 217 and 218 only.
Place the three (3) safety stickers inside the pool in a way
that it's seen from any entry point of the swimmer (See
positionning drawing).