Elica PRF0147272 Prescriptions De Montage Et Mode D'emploi page 29

standards which assures the complete disconnection of the
mains under conditions relating to over-current category III, in
accordance with installation instructions.
WARNING!
Before re-connecting the hood circuit to the mains supply and
checking the efficient function, always check that the mains
cable is correctly assembled.
The hood is provided with a special power cable ; if the cable
is damaged, request a new one from Technical Service.
Mounting
Before beginning installation:
• Check that the product purchased is of a suitable size for
the chosen installation area.
• Remove the charcoal (*) filter/s if supplied (see also
relative paragraph). This/these is/are to be mounted only
if you want lo use the hood in the filtering version.
• Check (for transport reasons) that there is no other
supplied material inside the hood (e.g. packets with
screws (*), guarantees (*), etc.), eventually removing
them and keeping them.
Very heavy product; hood handling and installation must
be carried out by at least two persons.
Operation
ON/OFF light button
Press to turn the cooktop light on or off.
In selected models only:
Intensity regulation: With the light on,
press and hold to adjust the light intensity.
Tone regulation: With the light on, press
and hold keys "
the light tone.
"BOOST" speed selection key
1st push : to enable the intensive suction
speed "BOOST 1", timed for 30 minutes
this prolonged timing has been designed
to guarantee a suitable cooking time for
preparations that release high amounts of
smoke during cooking
Note : after 30 minutes, the hood will
return to the suction speed previously set
2nd push
activate the intensive suction speed
"BOOST 2", timed for 7 minutes
Note: after 7 minutes, the hood will return
to the previously set suction speed
3rd push ("BOOST 2" activated): to exit
the function and return to the speed
" and " " to adjust
("BOOST 1" activated): to
previously set.
Note: the speed key previously set
remains lit during BOOST operation.
Speed selection key 3
Push to activate the high speed (suction
power)
Speed selection key 2
Push to activate the
(suction power)
Speed selection key 1
Push to enable the low speed (suction
power)
Power button
Push to switch on the hood and enable
speed selection;
if pushed while the motor is running, the
latter will stop
Note: if no function is activated within 10
seconds, the hood turns off.
Filter Saturation indicator lights
The hood signals at regular intervals that the filters must be
serviced.
Keys " " and "
service the grease filter.
Keys " " and "
the odour filter.
Note: The filter saturation warning signal is visible within
the first 10 seconds after the hood is switched on.
Reset filter saturation indicator:
Press and hold the keys "
The keys will flash quickly to confirm that reset has been
completed
Activation of filter saturation indicators
Note: this operation must be performed with the hood off.
- Grease filter
Push and hold down the keys "
activate the function
the keys light up flashing very slowly, indicating that the
grease filter indicator can be activated
Note: Push the keys " " and "
- Odour filter
Push and hold down the keys "
activate the function
29
average speed
" lit and flashing very slowly:
" lit and flashing quickly: service
" and " "
" and "
" to activate or deactivate
" and "
" to
" to