Precautions; Stand Removal / Wall Mounting; Getting Started; Remote Control Battery Installation - Sanyo DP50749 Manuel D'instructions

STAND REMOVAL AND WALL
MOUNTING
(OPTIONAL)
Tools Needed: Phillips screwdriver No. 3
IMPORTANT NOTE:
Place HDTV face down on a padded or cushioned
surface that is larger than the screen size to pro-
tect the screen and finish. Handling by more than
two people is recommended.
Wall mounting of the HDTV must be performed
by a skilled person.
1 Remove four (4) screws from the metal bracket.
CAUTION
: Hold the stand firmly as you
remove the last screw.
2 Carefully remove the stand.
3 Use the screws that are threaded into four (4)
of the six (6) inserts on the back of your
Plasma HDTV to secure it to a wall mounting
kit (not included.)
UNIVERSAL standard interface:
480 x 200 and 480 x 360
Mounting screws measurements:
M6 Diameter, Length—18mm (max.)

GETTING STARTED

BATTERY INSTALLATION
Install batteries in the remote control
( 2 "AAA", not included)

PRECAUTIONS

To ensure safe operation, please observe
the following precautions:
• Replace both batteries at the same
time. Do not use a new battery with
a used battery.
• There's a risk of explosion if a battery
is replaced by an incorrect type.
• Do not expose the Remote Control unit to moisture
or heat.
• Be sure to match the "+" and "
batteries with marks inside the remote control.
ANTENNA CONNECTION FOR
OFF-AIR SIGNALS OR CABLE
ANTENNA
CABLE
The tuner in this HDTV can receive:
• Digital and Analog off air signals from an antenna
• Analog or ClearQAM cable channels from a direct
Cable TV connection.
www.sanyoctv.com
Need help?
–
" signs on the
ANALOG / DIGITAL
ANTENNA IN
5
1-800-877-5032