Important Safety Instructions - Mi-T-M HDB Serie Manuel De L'utilisateur

WARNING: When using this product, precautions should always be observed, including the following.
READ ALL SAFETY WARNINGS BEFORE USING PRESSURE WASHER
HAZARD
RISK OF
EXPLOSION OR FIRE
4

IMPORTANT SAFETY INSTRUCTIONS

POTENTIAL CONSEQUENCE
Serious injury or death may occur
from normal sparks in the multiple
ignition sources or engine/burner
exhaust.
Serious injury or death may occur as
a result of improper fueling.
Serious injury or death may occur
from the battery.
PREVENTION
Always operate pressure washer in a well
ventilated area free of flammable vapors,
combustible dust, gases or other combustible
materials.
Do not store the pressure washer near an
open flame or any equipment such as a stove,
furnace, water heater, etc., which utilizes a pilot
light or sparking device.
Do not use this pressure washer to spray
flammable material!
Do not smoke while filling fuel tanks.
Never fill the fuel tanks while the engine is
running or hot. Allow the engine to cool two
minutes before refueling.
Do not refuel indoors or in a poorly ventilated
area.
Always refuel slowly to avoid the possibility of
spilled fuel which may cause a risk of fire.
Engine Fuel Tank:
If using a Gasoline Engine, refuel with gasoline
only. Do not use diesel or fuel oil.
Burner Fuel Tank:
When refueling the Burner Fuel Tank, use
No. 1 or No. 2 fuel oil/diesel or kerosene. Do
not use gasoline, crankcase drainings, or oil
containing gasoline or solvents.
Do not operate the unit if gasoline or diesel
fuel is spilled. Wipe the pressure washer
clean and move it away from the spill. Avoid
creating any ignition until the gasoline or diesel
fuel has evaporated.
When the battery is being activated, hydrogen
and oxygen gases in the battery are extremely
explosive. Keep open sparks and flames away
from the battery at all times, especially when
charging the battery.
Be certain to disconnect the battery ground
terminal before servicing. When disconnecting
the cable from the battery,
negative terminal, and when connecting them,
start with the positive cable.
When charging the battery, remove the battery
vent plugs.
Use only a voltmeter or hydrometer to check
a battery charge.
DO NOT jump start the battery unless
both batteries are of equal voltage and
amperage.
HDB/HDD-SERIES Operator's Manual
start with the