Pairing A Bluetooth Device - ION TOTAL PA GLOW 2 Guide D'utilisation Rapide

Operation

Pairing a Bluetooth Device

1. Turn on your Bluetooth device.
2. Power on Total PA Glow 2.
3. Use the Mode button to select Bluetooth as the audio source, which appears as "bt" in the
display. Total PA Glow 2 will automatically go into pairing mode to search for Bluetooth devices.
You will know you are in pairing mode when the Bluetooth icon is flashing. In addition, automatic
voice prompts from the speaker will alert you of the device's status: Bluetooth Pairing,
Bluetooth Connected, or Bluetooth Disconnected.
4. Navigate to your Bluetooth device's setup screen, find Total PA Glow 2, and connect. The
Bluetooth icon will remain solidly lit.
Note: Users should consider updating their device's OS if experiencing trouble with pairing or
playing music.
5. To disconnect pairing, turn off Bluetooth on your device or select Forget this device on your
Bluetooth device's setup screen.
If you would like to disable (or enable) the voice prompts, press and hold the Play/Pause button on
the Media Panel.
Note: Bluetooth must be selected as the audio source in order to disable (or enable) the voice
prompts.
Connecting Two Speakers
To link two Total PA Glow 2 speakers:
1. With the Power Switch on each speaker turned to the off position, connect each speaker to a
power outlet.
2. Plug an XLR cable into the Mix Out located on the rear panel of one Total PA Glow 2 speaker.
This speaker (the master) is the one to which you will connect audio sources such as a Bluetooth
device, microphone, or USB flash drive.
3. Plug the other end of the XLR cable into the XLR Input on the rear panel of your second Total PA
Glow 2 speaker. This second speaker will receive the audio from any devices connected to the
first speaker (the master).
4. Power on both speakers using their Power Switches.
5. Connect your audio sources to the first speaker (the master).
6. Make sure that each speaker's Master Volume control is set to the same position.
7. With one of your audio sources playing, gradually turn up the Aux Input Volume on the second
Total PA Glow 2 speaker until the volume of this speaker matches the volume of the first speaker
(the master).
8