Use; Filling The Boiler When Cold; Ironing; Filling The Boiler When Hot - Imetec IRON MAX Mode D'emploi

GB

USE

FILLING THE BOILER WHEN COLD

1. Ensure that the appliance is not connected to the mains.
2. Unscrew the safety cap (1) completely and fill the boiler using the funnel provided (13), being careful not
to overfill. The boiler has a capacity of approx. 1 litre.
3. At the end of the operation, screw on the safety cap (1) tightly.

IRONING

• Insert the plug (4) in a suitable socket;
• press the on/off switches for the boiler (2) and iron (3). The plate temperature indicator light (10) will turn on;
• adjust the iron temperature regulation knob according to the international symbols found on the garment
label. Wait until the indicator light (10) goes off;
• begin ironing when the steam ready indicator light (5) comes on. While ironing, the steam ready indicator
light (5) and the plate temperature indicator light (10) go on and off, indicating that the machine is maintaining
the pressure and temperature at optimal levels.
• to steam iron, press the steam release push-button (11);
• turn the steam regulation knob (6) (where present) to regulate the quantity of steam desired.
• to dry iron, do not press the steam release push-button (11).
WARNING!
Never unscrew the boiler safety cap (1) during normal ironing operations.

FILLING THE BOILER WHEN HOT

When there is no more water inside the boiler, the iron stops producing steam and the no water indicator light
(7) turns on:
• turn off the boiler on/off switch (2) and the iron on/off switch (3);
• disconnect the plug (4) from the socket, wait a few minutes and loosen the safety cap (1) slowly to release
any remaining steam in the boiler;
• unscrew the safety cap (1) completely and wait a few minutes before filling up the tank;
• fill the boiler very slowly with water using the provided funnel (13), being careful not to overfill. The boiler has
a capacity of approx. 1 litre;
• at the end of the operation, screw on the safety cap (1) tightly;
• Start ironing again, following the instructions in the "IRONING" paragraph.
WARNING!
The temperature inside the boiler is very high. When cold water is added it immediately
vaporises and steam is let off. So pay the utmost attention when filling up.
PRESSURE GAUGE (where present)
The pressure gauge (8) keeps the steam pressure level in the boiler under control. While you are ironing, the
pointer will move according to the demand for steam and will position itself in the area between yellow and
green.

AFTER USE

• Turn off the boiler on/off switch (2) and the iron on/off switch (3);
• then disconnect the plug (4) from the socket;
• wait for the appliance to cool down before putting it away.
PLEASE NOTE:
If you do not expect to use the appliance for several weeks, empty the boiler completely:
• wait until the appliance is completely cold;
10
All manuals and user guides at all-guides.com