Scope Of Delivery; Description (Fi G. 1); Intended Use; Using An Extension Cable - BTI profiline A-BS 12V-2 Notice D'utilisation

Charges NiMH and NiCd battery packs.
Charges Li-Ion battery packs.
See technical data for charging time.

Scope of delivery

A-SBS A-SBS
18V LI 18V
Art.-Nr. 9023345 9023344
1 Cordless hammer
X
drill/driver
1 Cordless Combi Drill
2 Rechargeable batteries
X
(SYSTRA modul)
NiCd battery
Lithium ion battery X
1 Battery charger X
1 Operating instructions X
1 Exploded view X
• Check for damage to the tool, parts or accessories
which may have occurred during transport.
• Take the time to thoroughly read and understand this
manual prior to operation.
Description (fi g. 1)
WARNING: Never modify the power tool or
any part of it. Damage or personal injury
could result.

INTENDED USE

These drills/drivers/hammerdrills are designed for
professional drilling and screwdriving applications.
DO NOT use under wet conditions or in presence of
fl ammable liquids or gases.
These drills/drivers/hammerdrills are professional power
tools. DO NOT let children come into contact with the
tool. Supervision is required when inexperienced
operators use this tool.
a. Trigger switch
b. Forward/reverse button
c. Torque adjustment collar
d. Gear selector
e. Worklight
f. Keyless chuck
g. Battery pack
h. Battery release buttons
i. Main handle
Electrical safety
The electric motor has been designed for one voltage
only. Always check that the battery pack voltage
All manuals and user guides at all-guides.com
A-BS A-SBS A-BS
14,4V LI 14,4V 12V-2
9023343 9023341 9023340
X X
X X
X X X X
X X X
X
X X X X
X X X X
X X X X
55
corresponds to the voltage on the rating plate. Also make
sure that the voltage of your charger corresponds to that
of your mains.
Your BTI charger is double insulated in
accordance with EN 60335; therefore no
earth wire is required.
If the supply cord is damaged, it must be replaced by
a specially prepared cord available through the BTI
service organization.
Mains plug replacement (U.K. & Ireland only)
DANGER:
• Should your mains plug need replacing and you are
competent to do this, proceed as instructed below.
If you are in doubt, contact an authorized BTI repair
agent or a qualifi ed electrician.
• Disconnect the plug from the supply.
• Cut off the plug and dispose of it safely; a plug with
bared copper conductors is dangerous if engaged in
a live socket outlet.
• Only fi t 13 Amperes BS1363A approved plugs fi tted
with the correctly rated fuse (1).
• The cable wire colours, or a letter, will be marked
at the connection points of most good quality plugs.
Attach the wires to their respective points in the plug
(see below). Brown is for Live (L) (2) and Blue is for
Neutral (N) (4).
• Before replacing the top cover of the mains plug
ensure that the cable restraint (3) is holding the outer
sheath of the cable fi rmly and that the two leads are
correctly fi xed at the terminals crews.
WARNING: NEVER use a light socket.
NEVER connect the live (L) or neutral (N)
wires to the earth pin marked E or

Using an extension cable

An extension cord should not be used unless absolutely
necessary. Use an approved extension cable suitable for
the power input of your charger (see technical data).
E N G L I S H
.