ITC POWER TOOLS FSCN2-1 Guide D'utilisation page 3

All manuals and user guides at all-guides.com
IMPORTANT SAFETY INSTRUCTIONS
21. FIRE FASTENERS INTO WORK SURFACE ONLY. Do not drive staples nor
attempt to do so, into hard or brittle materials such as steel, concrete, or tile.
22. DO NOT DRIVE STAPLES too close to the edge of the workpiece. The work-
piece is likely to split, allowing the fasteners to fly free or ricochet causing
personal injury.
23. STAY ALERT. Keep hands and body away from the path of any potential fired
fastener. Watch what you are doing & use common sense. Don't operate any
tool when you are tired or under the influence of drugs or alcohol. Check pre-
scriptions to determine if there could be a problem.
24. GUARD AGAINST ELECTRIC SHOCK. Prevent body contact with grounded
surfaces: pipes, radiators, ranges, and refrigerator enclosures. Before driving
fasteners into walls, floors, or wherever "live" electrical wires may be encoun-
tered, try to ascertain whether there is a danger of shock.
25. KEEP WORK AREA CLEAR of obstructions.
26. STORE IDLE EQUIPMENT. When the tool is not being used, it should be
cleaned, and stored in a clean dry place out of the reach of children.
27. EMPLOYERS must enforce compliance with the safety warnings and all other
instructions in this manual. Keep it available for use by everyone assigned to
use this tool.
WARNING: The warnings, cautions, and instructions detailed in this manual
cannot cover all possible conditions and situations that occur. It must be
!
understood by the operator that COMMON SENSE AND CAUTION ARE
FACTORS that cannot be built into this product, but MUST BE SUPPLIED BY
THE OPERATOR.
UNPACKING
Check immediately that all parts and accessories are included. If anything is
missing or broken, contact your retailer.
 Hammer
 Nailer /Stapler
 S3 Hex key
 S4 Hex key
 S5 Hex key
 Instruction Manual
 25/32" Spacer (Installed)
 1/2" Spacer
SPECIFICATIONS
 Shoots standard Flooring Cleat Nails minimum 1-1/2" (38 mm) long to a
maximum length of 2" (51 mm)
 Shoots standard 15-1/2 ga. 1/2" crown flooring staples minimum 3/4" (19 mm)
long to a maximum length of 2" (51 mm)
 Operating pressure: 60-100 psi / 414 to 689 kPa / 4.14 to 6.89 bar
(max. 120 psi / 827 kPa / 8.3 bar)
 Air consumption: 5 cfm @ 80 psi / 552 kPa
 Nail Capacity: 100
 Staple Capacity: 80
 Air Inlet: 1/4" NPT
 Tool weight: 11.5 lb. / 5.2 kg
 Pkg. weight: 23.2 lb. /10.5 kg
1
1
1
1
1
1
1
1
3
v.081121