BEARWARE 303162 Manuel page 13

30 seconds - 2 minutes alarm: continuous beep
If the alarm is not turned off within 2 minutes, it switches off automatically.
Press the "Snooze/light" button during the alarm to activate the Snooze mode
and to temporarily turn off the alarm. The alarm is turned off for about 5 minutes
and then goes off again. A snooze symbol appears on the display when the snooze
mode is active.
Press any button (except the "Snooze/light" button) to turn off the alarm. The
alarm will be enabled again on the next day at the configured time, unless you
turn off the alarm using the "ALM/SET" button and the alarm symbol is no longer
shown in the display.
7. Safety instructions and liability disclaimer
Never try to open the device to carry out repairs or conversions. Avoid contact
with mains voltages. Do not short-circuit the product. The device is not certified
for use in the open air; only use it in dry conditions. Protect it from high humidity,
water and snow. Keep it away from high temperatures. Do not subject the de-
vice to sudden changes in temperature or heavy vibration as this might damage
electronic components. Examine the device for damage before using it. The unit
should not be used if it has received an impact or has been damaged in any other
way. Please observe national regulations and restrictions. Do not use the device
for purposes other than those described in the instructions. This product is not a
toy. Keep it out of the reach of children or mentally impaired persons. Any repair or
alteration to the device not carried out by the original supplier, will invalidate the
warranty or guarantee. The product may only be used by persons who have read
and understood these instructions. The device specifications may change without
any separate prior notice to this effect.
13
English