BEARWARE 303162 Manuel page 11

5. Key functions
"WAVE"
Press to enable or disable the radio mode
button
• Press and hold to access the alarm settings
"ALM/SET"
• Press to turn the alarm on or off
button
• Press once in the settings to confirm the setting
"Up" button Increase the desired value (e.g. alarm time, time)
"Reset"
Reset the device to factory settings
button
"TIME/SET"
Press and hold to access the time settings
button
"Snooze/ • Enable the snooze function
light" button • Enable the backlight
6. Commissioning
Take the device out of the package and remove all the packaging material. Open
the battery compartment on the back of the device and insert two 1.5V AAA
batteries. Make sure the polarity of the contacts is correct. Then close the battery
compartment.
The radio alarm clock now automatically tries to receive a radio signal. Press the
"WAVE" button if you want to cancel this step. The radio symbol in the display
disappears.
6.1 Radio signal
Press the "wave"button to enable or disable the radio search mode. The radio
symbol appears on the display when the search mode is enabled.
The radio alarm clock searches for a signal every day at 1:00, 2:00, 3:00, 4:00 and
5:00 a.m.
English
11