Marco UP9-XA 12V Mode D'emploi page 7

Self-priming electric pump for the transfer of liquids of varied nature for discontinuous or
intermittent usage.
The pumping elements are made up of PTFE gear drives which can possibly even run dry
for brief periods. Completely equipped with in-line filter on the inlet side.
CODE TYPE
164 103 12
UP9-XA
164 103 13
Temperature: min. -10 °C / max. +60 °C
Warning: the above indicated temperature ranges are applicable to all components of the
pump and these limits must be respected in order to avoid any possible damage or
malfunctioning.
ELECTRICAL CONNECTIONS
The electric pump must be connected to a source of direct current (either battery or
transformer) with an amp rating of over 15 A and 7,5 A at nominal voltage of 12V and 24V
respectively. The pump must be protected by a suitable rated fuse.
The pump has been designed for discontinuous use. Under conditions of high operating
pressures (eg. with closed or blocked outlet, excessive length of the delivery circuit and/or
excessive pressure due to accessories), the pump can be subjected to elevated stresses
and overheating and therefore should not be used for prolonged periods under such
conditions.
There are numerous fields of applications for the pump, however only exclusively with
the allowed liquids mentioned:
- transfer of fluids in the chemical field;
- transfer of acid and alkaline solutions;
- transfer of acid solutions for batteries.
PRODUCT DESCRIPTION
TECHNICAL DETAILS
VOLT FUSE FLOW RATE
12 15 A
24 7,5 A
AMBIENT CONDITIONS
OPERATING CYCLE
APPLICATIONS
©
PRESSURE WEIGHT P.CS x CART.
12 l/min 5 bar
Relative humidity: max. 90 %
7
S.p.A.
E N G
A
B
2,7 kg 6
C
D
E
F