Worx HYDROSHOT WG630E Manuel page 16

OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the
instruction book carefully.
INTENDED USE
This tool is intended for cleaning and watering.
ASSEMBLY & OPERATION
ACTION
BEFORE OPERATION
Installing the battery pack
Removing the battery pack
Checking the battery condition
NOTE: Fig. A3 only applies for the
battery pack with battery indicator light.
Charging the battery pack
More details can be found in charger's
manual
ASSEMBLY
NOTE: The power nozzle has two
working modes: short lance only and
short lance used together with
extension lance.
Working mode 1
Attaching short lance to the power nozzle
16
NOTE: When attaching, align the
two projections on the lance with the
grooves of the power nozzle as shown
in Fig. B.
Attaching the Multi-spray nozzle
NOTE: When attaching, rotate the
nozzle left and right to make sure the
nozzle fully seated into position and
gently pulling it to make sure it is
locked into position securely.
Attaching the hose to the power nozzle
NOTE: After the hose is attached, check
the connection by gently pulling upon
the hose. It should not be pulled off.
Attaching your own water hose
(optional)
1. Remove the hose adapter
2. Attach the home garden hose with
suitable connectors
NOTE: Besides the hose supplied, you
can also connect the power nozzle to
your own water hose with suitable
connectors.
NOTE: Check whether the filter screen
is missing before retightening the hose
adapter. When retightening the quick
hose adapter, please tighten securely.
Otherwise, it may not draw any water
for proper operation.
2 in 1: Portable Power
Cleaner/Water Sprayer
OPERATION
WARNING: The supplied
battery is not waterproof. To
avoid risk of battery failure, protect
the battery from water exposure
during use. Store the tool and
battery in a dry place after use.
Start
NOTE: At the first use, you need to
FIGURE
empty the air in hose, place the
power nozzle below waist level
(<1.5m/5ft) and set it at high pressure.
Do not start working until the water
See Fig. A1
goes up along the hose and
See Fig. A2
sprays out. This could take up to 30
seconds or more depending on
the fresh water source.
See Fig. A3
Selecting the nozzle pattern
NOTE: Choose a suitable nozzle pattern
See Fig.
according to your work. Spray
A4, A5
patterns 0
applicable for cleaning, and the spray
pattern with the symbol
suitable for watering.
WARNING: Do not shift the
nozzle pattern when the tool is
powered on.
Cleaning
See Fig. B
WARNING: Do not connect the
machine to water supplies that
are dirty, rusty, muddy, or
corrosive. (Including window
cleaning liquids, plant foods, or
fertilizers etc.)
NOTE: For proper maintenance after
using with sea water, the product
should be rinsed by fresh water.
See Fig. C
Watering
ATTACHMENT OF
See Fig.
D1, D2
ACCESSORIES
A number of accessories have been supplied with
this product and are required for use in different
applications. Do not attempt to use cleaning
without a lance or any accessories attached.
1. Soap bottle (WA4036, sold separately)
Soap bottle provides detergent suds for deeper
See Fig.
cleaning of dirt. It is used in conjunction with power
E1, E2, E3
nozzle or extension lance. (See Fig. K1, K2)
2. Brush (WA4048, sold separately)
Brush is for cleaning cars, boats, motorcycles
etc. It is used in conjunction with power nozzle or
extension lance. (See Fig. L1, L2)
o , 15 o , 25 o and 40 o are
is best
See Fig. F
See Fig. G
See Fig.
H, I
See Fig. J
EN