Lubrication; Storage; Troubleshooting - Shop-Vac shop-air WAIR Serie Manuel De L'utilisateur

No lubrication is necessary as the motor is equipped with lifetime lubricated bearings.
1. before storing the unit, it should be cleaned. For cleaning instructions, refer to the cleaning section in this
manual.
2. If desired, the unit may be removed from the wall bracket by removing the bolt. The power cord can be
wrapped around the handle on the top of the unit to keep it untangled. THE AIR CIRCULATOR SHOULD
BE STORED INDOORS.
PROBLEM
Loss of airflow or
unit runs hot
Will not start
ONE YEAR INDUSTRIAL/COMMERCIAL WARRANTY
Limited One-Year Warranty
Shop-Vac Corporation warrants the product contained in this package for one year from the date of
purchase to correct by repair or parts replacement without charge any product defect due to faulty material
or workmanship. Should this product be used for rental service, a 90 day limited warranty will apply. Shop-
Vac assumes no responsibility for damage or faulty performance caused by misuse or careless handling,
®
or where repairs or modifications have been made or attempted by others. Proof of purchase date is
required. This warranty gives you specific legal rights, and you may also have other rights which vary from
state to state or province to province.
Customers in the United States: for product service contact Shop-Vac Corporation, Customer Service, at
(570) 326-3557 or go to www.shopvac.com/support. Visit www.shopvac.com for your parts list
schematic.
Customers in Canada: for product service return the complete unit, (transportation prepaid), to the
Authorized Shop-Vac
Service Centers in your area.
Customers in Mexico: for product service see paperwork that came with your unit.
PAGE 6

LUBRICATION

TROUBLESHOOTING

POSSIBLE CAUSES
1. Clogged filter
1. Power cord not plugged into
outlet
2. No power at the outlet
3. Defective switch or motor
Service Center nearest you. Visit www.shopvac.ca for a complete list of Authorized
®

STORAGE

SOLUTION
1. Clean or replace filter
1. Plug cord into outlet
2. Plug cord into another outlet
3. Contact Shop-Vac
customer service
®