Set Up And Operation; Optional Filters And Accessories; Cleaning; User Servicing Instructions - Shop-Vac shop-air WAIR Serie Manuel De L'utilisateur

6. Install air circulator onto bracket making sure to point the side closest to the switch in the direction you
want the air to flow. To install, place handle on air circulator in U-shaped slot on end of the pivot tube.
7. Line up hole in the pivot tube with the hole in the handle. NOTE: There are two sets
of holes in the handle. Use the vertical set if the bracket is mounted to the wall and
the horizontal set if the bracket is mounted to the ceiling. Insert remaining bolt, with
washer, through the holes. Place lock nut on end of bolt and hand tighten only.
8. The angle of the unit may be adjusted by turning the unit and/or the pivot tube. If it won't turn, loosen
the bolts. Once the unit is in the correct position, tighten both of the bolts and lock nuts using two 9/16"
wrenches or sockets. NOTE: you will feel some resistance from the lock nut. This is normal. Continue to
tighten until the nut touches the pivot tube.
WARNING
USE THIS AIR CIRCULATOR WITH ANY SOLID-STATE SPEED CONTROL DEVICE.
1. Plug the unit into the wall.
2. Turn unit on and select air speed by turning switch, located on the top of the unit.
3. When you no longer need the unit, turn the unit off and follow the instructions for storage in this manual.

OPTIONAL FILTERS AND ACCESSORIES

There are filters and accessories available for the air circulator that may be purchased at your local dealer
or Shop-Vac website. These items do not come standard with your unit.
®
FILTERS
The available filters install on the intake end of the air circulator to prevent dust from being drawn into
the unit and exhausted into the air. To use the filters, you will need to purchase the filter kit containing the
mounting ring. NOTE: Filters are not required in areas where the dust content is low.
WARNING
DEPENDENT ON THE FILTER. A CLOGGED FILTER CAN CAUSE OVERHEATING AND POSSIBLY
DAMAGE THE UNIT. CHECK THE FILTER PERIODICALLY AND REPLACE AS REqUIRED.
ACCESSORIES
The mobile floor mounting bracket allows you to move the unit around for use in different spaces. The
loading dock air circulating kit forces cool air into a trailer and warm air out.
WARNING
ACCIDENTALLY STARTING, UNPLUG POWER CORD BEFORE CLEANING.
The outside of the unit may be cleaned with a damp cloth to remove any dust or residue.

USER SERVICING INSTRUCTIONS

WARNING
ATTEMPTING TO SERVICE OR REMOVE ANY COMPONENTS.
Do not attempt to service your air circulator beyond that described in the user manual. For all other
servicing, follow instructions under Warranty Section.
ASSEMBLY (CONT'D)

SET UP AND OPERATION

–
TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT
–
KEEP FILTERS CLEAN. EFFICIENCY OF THE UNIT IS LARGELY

CLEANING

–
TO REDUCE THE RISK OF INJURY FROM THE AIR CIRCULATOR
–
BE SURE TO DISCONNECT POWER SUPPLY BEFORE
PAGE 5