Decommissioning; Spare Parts Service; Warranty Conditions; Troubleshooting - Schneider Airsystems BM-W 510 Notice D'utilisation D'origine

GB
BM
2.6

Decommissioning

Storage: Clean, dry, dust-free,
not below 5° C.
Disposal: Dispose of the packaging / device
/ materials used according to applicable legal
regulations.
2.7

Spare parts service

Visit our website
tems.com/td/ for the latest version of all ex-
ploded drawings and spare parts lists for our
products. If you have any special questions,
please consult the Schneider Airsystems Ser-
vice centre in your country (addresses in the
service appendix) or your local dealer.
2.8

Warranty conditions

Basis for warranty claims: complete unit
in original condition/proof of purchase.
2.9

Troubleshooting

Observe the safety instructions and maintenance instructions!
Problem
A Drill does not work
properly
B No satisfactory drill-
ing possible
*For troubleshooting: refer to the information in the "Technical data" chapter in part 1 of the instruction manual!
**See Chapter: "Intended use" in Instruction manual part 1!
****For troubleshooting: read chapter: "Maintenance"!
If necessary, contact our service staff, see last page.
II/ 5
All manuals and user guides at all-guides.com
www.schneider-airsys-
Cause
Drill worn or broken off
Incorrect drill in use
Working pressure (flow pres-
sure) too low
Compressor output too small
No lubrication present
Tool worn
Unsuitable material for the
device used
According to legal provisions, you re-
ceive the following warranty against
material and manufacturing defects:
private use only: 2 years,
commercial use: 1 year.
Excluded from warranty claims: Wear or
expendable parts, improper use, overloading
/ incorrect pressure, manipulation / inappro-
priate use, inadequate / incorrect / lack of
maintenance or lubrication, bumps / im-
pacts, dust / dirt accumulation, unauthorised
/ incorrect working procedures, incorrect
power supply, impure / insufficiently filtered
compressed air, failure to read the instruc-
tion manual, incorrect operating resources /
materials.
Remedy
Grind or replace drill
Use drill that is suitable for the
*
material
Increase working pressure (flow
pressure)
working pressure
Use different output
*
rating
Lubricate device
Replace tool
Use suitable material for the de-
**
vice
Observe maximum
*
****