Before Starting The Equipment - Kawasaki K-EHD 1050 Traduction De La Notice Originale

• Do not overload the appliance.
• Have the appliance serviced whenever
necessary.
• Switch the appliance off when it is not in
use.
• Wear protective gloves.

7. Before starting the equipment

Important!
Before you connect the equipment to the
mains supply make sure that the data on the
rating plate are identical to the mains data.
Always pull the power plug before making
adjustments to the equipment.
Check the drilling point for concealed electrical
cables, gas and water pipes using a cable/pipe
detector.
7.1 Additional handle (Fig. 2 – Item 3)
For safety reasons you must only use the
hammer drill with the additional handle.
The additional handle (3) enables you to
achieve better stability whilst using the
equipment. Do not use the equipment without
the additional handle (3). The additional handle
(3) is secured to the equipment by a clamp.
Turning the additional handle (3) clockwise
tightens this clamp. Turning it anti-clockwise will
release the clamp.
• The supplied additional handle (3) must first
be fitted. To do this, turn the additional
handle (3) until the clamp is opened wide
enough for you to slide the additional handle
(3) onto the equipment.
• After you have mounted the additional
handle (3), swivel it to the most comfortable
working position for yourself.
• Now turn the additional handle (3) in the
opposite direction again until the additional
handle (3) is secure.
• The additional handle (3) is suitable for both
All manuals and user guides at all-guides.com
left-handed and right-handed users.
7.2 Tool insertion (Fig. 4)
• Clean the tool before insertion and apply a
thin coating of drill bit grease to the shaft of
the tool.
• Pull back and hold the locking sleeve (2).
• Turn and push the dust-free tool into the tool
mounting as far as it will go. The tool will
lock automatically, after the locking sleeve
is released.
• Check that it is properly secure by pulling
the tool.
7.3 Tool removal (Fig. 5)
Pull back and hold the locking sleeve (2) and
remove the tool.
7.4 Dust collection device (Fig. 6)
Slide the dust collection device (14) over the
drill bit before carrying out any hammer drilling
vertically above your head.
8. Starting up
Important!
To prevent all danger, the machine must
only be held using the two handles (3/6).
Otherwise there may be a risk of suffering an
electric shock if you drill into cables.
8.1 Status indicator (Fig. 1/Item 11)
The status indicator (11) lights up when the
power plug is connected.
8.2 ON/OFF switch (Fig. 7/Item 10)
• First fit a suitable drill bit into the tool (see
7.2).
• Connect the mains plug to a suitable
socket.
19
GB