Ramili baby RA300 Manuel De L'utilisateur page 17

to transmit, its BU number or name will show flashing on LCD to alert the parent.
If parent prefers to listen to this BU, he can short press
will switch to listen to this BU. This BU number or name will show up on the LCD
while the original BU number or name will start flashing (in case the original BU
still transmitting). Pressing the
By doing this, the parent is able to monitor both babies.
10. You can use the
is more than one BU, the LCD screen will alternately show the information (room
temperature, battery level, breathing pace) of each BU for 15 sec. When one of
the BUs starts to transmit, the unit will immediately listen to that BU and the LCD
screen will show information from it until the signal goes off.
11. This PU is equipped with a vibrating alert. When the vibration feature is set to ON,
the vibration icon
loud enough, the vibrator starts functioning. This feature is useful when the parent
is working in a very noisy environment (e.g. vacuum cleaning). To save battery
power, it is recommended not to use the vibrating alert frequently.
12. Once the PU is outside of the communication range of the BU for more than
30 seconds, an out of range alarm will go off (if the alarm sound function is set
to ON). The text OUT OF RANGE will show up and the
the LCD backlight, will start flashing to alert the parents. Also, the temperature
reading will show - - °C. The alert will only stop when the PU falls back within
the communication range of BU. In case there are more than one BU, the out
User Instructions
All manuals and user guides at all-guides.com
button again will switch back to the original BU.
button for switching between units. In standby mode, if there
will show up on the LCD screen. Once the baby's voice is
EN
button and the unit
icon, together with
17