Input Jacks - Elite eXcursion 2000 Manuel D'utilisateur

P O W E R E D L O U D S P E A K E R S Y S T E M
Introduction
The Yorkville éXcursion 2000 is the ultimate all-in-
one complete PA system for live sound or mobile DJ
applications. The system includes one 18-inch high
efficiency subwoofer and two specially optimized
satellite speaker enclosures. The éXcursion 2000's
active crossover network and three amplifiers are
conveniently housed in the subwoofer enclosure. The
Class D and two 3-tier Class A/B amplifiers ensure ultra
quiet operation, low distortion and a high SPL output.
This is not a system that's been hastily put together; the
éXcursion 2000 was designed as a complete solution.
The system assembles into an integrated package
to make it easier for transportation and storage. The
éXcursion 2000 was designed for the road.
The éXcursion 2000 can be used as a single
system (subwoofer with two satellites) or as a dual
system using two éXcursion 2000 systems. When
the éXcursion 2000 is used in a dual system
configuration, each system behaves as individual
channels. The dual-system configuration allows the
use of the two satellite speakers on each side of the
stage that can be positioned for greater dispersion. The
éXcursion 2000 subwoofer has a pole-mount adapter
built-in to eliminate the necessity of using two speaker
stands. See your Yorkville dealer for information on the
variety of poles and stands available.

1. Input Jacks

i. Left & Right Input Jacks
The input jacks of the éXcursion 2000 are
designed for operation with line-level signals.
The XLR and balanced ¼-inch TRS jacks are
wired in parallel, functionally identical except for
the style of connector.
Note: The required input level for full power
operation, when the Level controls are set to
the center detent position, is approximately +4
dBv (1.2 volts). Increasing this setting allows
the éXcursion 2000 to be driven with sources
that have a low signal level.Connecting signals
to both types of inputs on any one channel
(XLR and ¼-inch) is not recommended.
ii. Aux Bal Subwoofer In Jack
This balanced input allows the subwoofer to be
fed from a separate signal source, other than the
signals being fed to the Left and Right amplifiers.
This feature allows the subwoofer to be mixed
separately from the Left and Right signals.
iii. Mono/Stereo Switch
In Stereo mode, the éXcursion 2000 routes the
two signals from the left and right inputs to the
corresponding satellite enclosures. If an individual
signal is sent to the éXcursion 2000, in either the
left or right channel, enabling the Mono mode will
route the signal to both satellite enclosures. If a
stereo signal is used, both the left and right will
be summed when the Mono mode is selected.
Note: Mono operation (using a single source)
will require setting the applicable level control
at a higher level.
2. Level Controls
i. Left & Right Level Controls
The Left and Right Level controls adjust
the output level of the corresponding satellite
enclosures. Adjustments can be made to alter
the balance of the satellites, compensate for
signal sources that are not the standard +4 dBv
line level or to tweak the SPL levels appropriate
to the application. The Left Level and Right
Level are normally set to the center detent.
1