Clip Indicators - Elite eXcursion 2000 Manuel D'utilisateur

ii. Subwoofer
Level Control
The Subwoofer
Level control allows
fine-tuning of the
low frequency
output. Adjustments
can be made to
compensate for
signal sources that
are not the standard
+4 dBv level.
3. Clip
Indicators
i. Clip Indicator
LEDs
The Clip Indicator
LED shows when there is ex-cessive input level on
either the Left or Right Inputs.
ii. Sub Clip Indicator LED
The Sub Clip Indicator LED indicates excessive
levels for signals going to the subwoofer
amplifier. Indications of excessive levels are
monitored either from the signals being sent from
the Left and Right Inputs or from the Aux Bal
Subwoofer In jack.
4. Protection
The éXcursion 2000 uses a sophisticated, multi-
stage limiting system that prevents clipping of the
amplifiers while accommodating a wide range of
input levels. The limiter circuitry protects the entire
system against most instances of overpowering.
Note: Continuous acoustic feedback may cause
damage to the light bulbs (CTL™ horn protection
circuitry) or to the speakers in the satellites.
1/4-inch T.R.S.
Phone Plug
Tip = 0°
Sleeve = Ground
LEFT RIGHT
LEVEL LEVEL
CLIP
STEREO
MONO
LIMIT
dB dB
00 12 00
I N P U T S
L E F T R I G H T
BAL
L E F T R I G HT
Ring = 180°
2
SUBWOOFER
LEVEL
SUB CLIP
SUB LIMIT
dB
12
00 12
A U X B A L
SUBWOOFER IN
BAL
indicated. When the unit is driven into limiting, the
internal Limiter circuit becomes triggered and will
reduce the gain. This will not significantly degrade
the sound quality.
Note: Operating a few dB into limiting will
ensure that the system is operating at its
maximum output. Operating excessively into
limiting will make the system more susceptible
to feedback.
ii. Sub Limit Indicator LED
The Sub Limit Indicator LED illuminates when
the maximum recommended operating-level of
the subwoofer has been reached. Increasing the
input signal level or turning up the Level controls
will not increase the operating level beyond
the limit indicated. When the internal Limiter
circuit becomes active the sound quality will not
significantly be degraded.
XLR Plug
(Male)
Pin 1 = Ground
Pin 2 = 0°
1 2
Pin 3 = 180°
3
Balanced 1/4-inch T.R.S. to Balanced XLR
i. Limit
Indicator LED
The Limit Indicator
LED indicates
when the maximum
operating level for
the satellites has
been reached.
When the LED is
illuminated, the
circuitry is actively
limiting the output.
Increasing the
input signal level
or turning up the
Level controls will
not increase the
operating level
beyond the limit