Bimar YDHB-002 Notice D'installation page 13

All manuals and user guides at all-guides.com
Fax +32 030 9904733
Ideal for:
- shredding and chopping foods devoid of hard parts (shells or as the core of
pineapple)
- grinding raw and cooked meat (first remove any bones, cartilage, skin and tendons),
vegetables, herbs, peanuts, walnuts and crumbled biscuits and bread.
• Avoid fibre-rich foods (meat) or particularly hard foods (ice, cheese rinds, coffee
beans, hard spices such as cloves, dill and cumin, which can damage the plastic
parts).
It is advisable to cut food into cubes of about 1 ~ 2 cm.
For this feature, use: the engine body (B), lid (H), blades (I), bowl (G).
• Use the pin to attach the blades to the shaft inside the bowl, being careful not to cut
yourself.
• Place food to be chopped in the bowl, Never fill the beaker less than the maximum
level (MAX).
• Place the lid on the engine body, then turn the lid clockwise until it locks (you will
hear a click upon correct entry) in direction simboly
to ensure that the lid is securely attached to the engine body.
• Place the engine body with lid previously assembled on the bowl, so that the slots of the lid (J) are
threaded into the hooks of the bowl (K) and turn the bowl clockwise until it locks (you will hear a
click for the correct insertion ). Use slight hand pressure to ensure that the engine body and lid are
securely positioned on the bowl. Before use, ensure that all elements (engine body, lid, shaft and
bowl) have been inserted properly.
Using the appliance
• Before each use, check that the equipment is in good condition, that the wiring is not damaged: if
the power cable is damaged, it must be replaced by the manufacturer or its technical assistance
centre or by someone who is similarly qualified, in order to prevent any risks.
• Plug into the power point.
• During use, it is necessary to hold the beaker or the container or bowl with the ingredients firmly
with one hand and the engine body with the other.
• The engine body is equipped with a pressure switch (A) with two speeds (minimum "I" and
maximum "II"): press the desired speed to operate the engine and vice versa release it to turn it off.
• The appliance can operate continuously for up to fifty seconds, after which requires a break of at
least 10 minutes before using it again. Failure to do this may affect the performance of the
appliance. It is recommended to use the appliance for short on / off periods: this will improve the
preparation of food, and this ensures a longer life of the engine.
• If the blades or the whisk get blocked, disconnect the appliance from the mains and remove the
ingredients that are blocking the blades.
• When you having finished using the blend: release the switch selected, wait for the blades to come
to a complete stop and remove the plug from the socket.
If the appliance is not in use for long periods of time, remove the plug from the plug point.
Practical advice for using the chopper
To achieve fine and uniform chopped pieces, cut solid foods into small pieces before putting them in
the appliance; in some cases (e.g. parsley) is advisable to occasionally stop the device, mix the
contents and chop again.
To achieve fine and homogeneously chopped pieces, remove the food from the wall of the bowl (C) if
necessary and bring it to the centre using a spatula, after having removed the engine body and
unplugging it from the mains.
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Bimar
(Italy). The pages must be reproduced and folded in
order to obtain a booklet A5 (+/- 148.5 mm width x 210
mm height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don't
change the page numbering. Keep the language
integrity.
. Use slight hand pressure
13/40
Assembly page 13/40