VANA SP1312 Notice De Montage page 66

Step 6: Install awning
After all three brackets have been mounted properly you can install the awning. At least three ladders
or treads are required to install the awning in order to obtain the required height. Ensure that the lad-
ders/treads firmly rest on the ground so that you cannot fall. Only use ladders/treads that are suitable
for such assembly work.
Insert the awning into brackets as shown in the drawing below. Then immediately secure it with deli-
vered round head bolts to the brackets. Tighten the nut of the round head bolt firmly.
Figure 6:
As shown in figure 6.1, loosen the
screws that are fixed to the wall.
As shown in figure 6.2, tighten the
bolts when the awning has been
tightly installed to the brackets.
In order to hang the awning on the wall and buckle on the bolt more easily, loosen the bolt at the
appropriate position only when the awning is positioned directly above the bolt.
Note: After installing the awning you have to check if all bolts are connected tightly.
Remove the safety belt after mounting; otherwise the awning cannot be extracted. Keep the belt;
you can use it when storing the awing.
Attention: Misplacing and misapplying the awning can cause serious danger. Only mount the
awning yourself when you understand the mounting instructions completely and when you are sure
that the wall you want to mount the awning on is suitable. For your own and the safety of other
people please contact an authorized assembler for help.
Figure 7:
Fasten locking rings as shown
in the figure below. Tighten the
hexagonal nuts which are to
be fixed to the veneer of the
awning at the motor; do this by
tightening the locking ring to the
hinge (pull the rings out after-
wards).
All manuals and user guides at all-guides.com
6.1
- 66 -
6.2