Assembly
Prior to each use, check the machine for da-
mage and have damaged parts replaced be-
fore using.
Keep others, especially children and pets,
away from the operating area.
The machine operator or user is responsi-
ble for accidents involving other persons and
their property.
Children and persons who are not familiar
with operation are not permitted to use the
snow blower.
Observe the local regulations governing the
minimum age of the operator.
Do not operate when under the influence of
alcohol, drugs or medication.
Wear appropriate work clothing.
Winter clothing
Sturdy, non-slip footwear
Eye protection (safety glasses or visor)
Hearing protection
Work only when there is adequate daylight or
artificial lighting. Adjust your speed to condi-
tions. Walk, don't run.#
Keep hands, feet and clothing away from the
auger and impeller.
Observe local ordinances regarding opera-
ting times.
Never leave the machine unattended when it
is ready for operation.
Be careful when working on slippery sur-
faces. Danger of slipping, especially when
moving in reverse.
➯ Adjust your speed to conditions.
In the following situations, switch off the en-
gine and wait until the machine is at rest, then
disconnect the spark plug connector:
When not using the machine
During cleaning and maintenance
Before making adjustments
When malfunctions occur
Before loosening blockages
Before unclogging
After hitting obstacles
If malfunctions or unusual vibrations oc-
cur
Do not clear snow from roofs.
440829_a
Do not use the machine on steep slopes due
to the risk of slipping or tipping. Exercise ad-
ditional caution when turning on sloped sur-
faces.
Never lift or carry the machine while the en-
gine is running.
Fremdkörper im Arbeitsbereich entfernen.
Use the skid plates to adjust the distance of
the clearing plate from the surface. Do not
operate the machine on gravel surfaces.
Do not eat, drink or smoke while filling with
petrol or engine oil.
Do not inhale petrol fumes.
Take precautions to ensure that discharged
snow does not cause injury to persons or
animals or damage to buildings, vehicles or
other objects. Make sure that traffic is not im-
paired and that drivers are not endangered.
Keep hands out of the snow discharge chute
while the machine is running.
Keep hands and feet away from the auger
and impeller while the machine is running.
ASSEMBLY
CAUTION!
Do not operate the machine until it has
been fully assembled.
Initial steps
1. Remove all the parts from the packaging.
2. Check all parts for transport damage.
➯ If you discover damage or if there are
parts missing, contact the dealer where
you purchased the machine immedia-
tely.
Attaching the guide handle
see Figure. (2a /2b)
1. Place the upper handle onto the lower handle
on the outside.
2. Insert the screws outwards from the inside
through the guide holes.
3. Tighten on both sides using the lock nuts.
4. Fastening cable guide to the leadership bar
and putting rope traction in.
➯ The guide handle is now attached.
Mounting the hand crank
The hand crank is used to adjust the discharge
direction.
see Figure (3a / 3b)
17