Useful Information - Stadler Form Poseidon Mode D'emploi

uSefuL iNfOrMAtiON:

Information on how an ultrasonic vaporiser works
How does the ultrasonic vaporiser work? An ultrasonic membrane in the in-
terior of the device causes the water to oscillate, causing very ine droplets
of water to be "catapulted off" from the water surface. These droplets mix
with the air in the spray chamber and are then blown into the room through
a ventilator as a visible spray. This ine spray evaporates in the warm air in
the room, moistening the air that people breathe.
White dust:
The ultrasonic vaporiser's method of action causes all substances contained
in the water to be sprayed, including calcium carbonate (a cause of lime-
scale) and minerals. In order to prevent this as far possible, the water is fed
through the ilter cartridge before being sprayed. The cartridge retains a
large percentage of the substances contained in the water. Tap water var-
ies greatly from region to region in terms of its calcium and mineral content.
Some minerals cannot be suficiently iltered by the descaling resin used. In
this case, a white, dust-like deposit is left in the room, which is irst visible
on electro-statically charged surfaces (such as TV sets). This deposit also
occurs when the ilter cartridge needs replacing (see the chapter on "Filter
Cartridge and Water Hardness").
Tips for water
Do not use water that has been subject to salt-based softening in a descal-
ing system. These systems replace the calcium with salt, which then settles
in the room as a white deposit.
Clean water must always be used to ensure that the air remains hygienic
to breathe. The device, and the water tank in particular, must always be
hygienically clean.
Recommendation: always use the Ionic Silver Cube (ISC ), as this reduces
™
the formation of germs in the water.
trOubLe-ShOOtiNG
"No Water" alarm light does not switch off after tank has been illed with
water:
The device switches off automatically if there is not enough water. The
"No Water" Light switches on (in red color) to warn you for the reill. To
restart the generation of mist, the device must irst be switched off and then
switched back on again (this resets the device). This is a protective function
for the ultrasonic vaporiser.
Device does not switch on although the water tank has been attached and
the on-button has been pressed:
This is not a malfunction. It takes few minutes till enough water runs from
the water tank through the cartridge and into the mist generation chamber.
Wait for a while and then press the on-button again.
The water tank is leaking:
Turn the Tank Cover anti-clockwise to take it off from the Water Tank, check
if the Cartridge if ixed irmly and put the Cover tank back on to the tank.
Low performance, no steam output, device not functional:
Perform maintenance as described in the chapter on "Cleaning Procedure".
rePAirS / DiSPOSAL
Repairs to all electric devices (including replacement of the power cable)