Important Safety Guidelines - Stadler Form Poseidon Mode D'emploi

Panel (7), the control display appears blue. The Mist Cap (2) can be
turned 360° or used bi-directional to have an even distribution of mois-
ture.
4. The desired air humidity level can be selected by pressing the Humidi-
ity button (12) on the Control Panal. The device will be shut off au-
tomatically when the room humidity reaches the given level. On the
Display panel (7), it shows the current humidity level in the room. By
pressing the Humidiity button (12), you will be able to set the desired
humidiity from 40%, 45%, 50%, 60% ,70% and "continous" model.
Release the button at your desired humidiity level or at continous
model, the unit is set and the display will switch to show the actual
room humidity level again. Note: on "continous" the unit will NOT turn
off automatically.
Caution: the device will not be switched on if the humidity level is set
too low.
5. Pressing the Output button (13) on the control panel, you can change
the volume of output mist from Level 1 to Level 3 (shown on the display
panel).
6. "Warm Mist" button (14): a heater can be switched on by pressing this
button. This heater will heat up the water to 80 C° before it enters into
the mist generation chamber. By this pre-heating function, the tem-
perature of the output mist will reach 40 C°, which will not cause the
room temperature to drop when mist evaporates. A LED light on top
the display panel will be switched on when this pre-heating function is
turned on. Press this button again to switch off is function, and the LED
light will be switched off.
7. "Night Mode" button (15): Pressing this button, the device is switched
to "night mode" with dim LED light. Press again, the device is back to
normal light mode. During this mode, the relative humidity will be kept
at a comfort level of 45%.
8. "Auto Mode" button (16): This button can set the humidiity level at
45% and the ventilator works at the optimal level 1. By pressing this
button, the previous humidity level set by "Humidity" button will be
canceled.
9. "No water" alarm light: At the lower part of the display panel, there is
red LED alarm light.
This light will on when there is no water or not enough water in the
mist generating chamber. When this light is on, you should switch off
the unit buy press the " On/Off Switch" and reill the Water Tank with
fresh water, put it back onto the unit and switch on the unit again. Note:
turn off the unit before taking off the tank. You need to turn on the unit
again when placing the tank back to the unit.
Althrough the unit shuts off its motor and its transdusor automatically
when water runs off and the "No water" LED light turns on, in order to
avoid unexpected damages, we recommend you to switch off the unit
by pressing the On/Off Button as soon as the "No water" Light is on.

iMPOrtANt SAfetY GuiDeLiNeS

Do not place the device directly on the loor. Moisture might not
evaporate and harm wodden loors or carpet.