Classic Accessories The Oswego Manuel De L'utilisateur page 13

O S W E G O P O N T O O N B O A T O W N E R ' S M A N U A L
9. Attach the pontoons to the frames.
Each pontoon attaches to a metal pontoon frame with four
webbing attachment straps.
Locate the left and right pontoon frames.
On the front of each pontoon frame (where the
front of the boat will be) there is a "L" (left) or
"R" (right) label indicating left or right.
Place a right pontoon frame on top of the
right pontoon as shown. There is a "L" (left)
or "R" (right) label inside the pocket of each
pontoon). The longest straight tube of each
frame should be on the same side of the
pontoon as the pontoon zipper.
Now attach the two inside and two outside webbing straps
on the pontoon to the pontoon frame. Thread the straps as follows:
1. Through the metal rectangle on the frame...
2. Back to the buckle...
3. Through the buckle threading path...
4. Match the rip-and-grip to each other.
5. Fold the remaining webbing. Back it through the metal rectangle
and trap it between the pontoon and webbing. Repeat for the
remaining three straps.
Repeat the procedure with the left pontoon.
10. Inflate the pontoon completely.
Finish inflating the pontoons as outlined in Step 3.
Inflate to approximately 2.5 psi (0.17 BAR). Inflate until firm but not hard. DO NOT
over inflate.
All manuals and user guides at all-guides.com
Illustrating right hand
pontoon and frame
13
FRONT
5.
2.
4. 1.
3.