Chapin 97902 Mode D'emploi page 11

ASSEMBLE DISCHARGE TO DIVERTING VALVE
8
Connect discharge with hose (C-15) to diverting valve as shown. Thread hose through loop clamp (H-8)( Figure A). Assemble worm gear clamp
(H-5) to hose (Figure B). Assemble hose to diverting valve (Figure C). Tighten worm gear clamp and loop clamp.
C-15
Image shown without frame legs
9 ASSEMBLE WAND TO SHUT-OFF
Make sure the O-ring is installed on the end of the extension wand (C-14). Insert the wand into discharge with hose (C-15). Turn and
tighten the retaining nut clock-wise onto the shut-off valve.
H-8
B
and handle bar for clarity
Retaining Nut
Wand (C-14)
H-8
Figure A
O-ring
Discharge with Hose (C-15)
10E
H-5
Figure B
Figure C