Mode Setting; Temperature Setting - ALPATEC RSB 24 Notice D'utilisation

All manuals and user guides at all-guides.com
notice RSB 24:notice RC_20ET
Place the heater on a flat and dry surface and plug in it.

MODE SETTING :

- Turn the power mode selector clockwise to choose the mode setting.
Position I : Fan function
Position II : low power heating (1100 W)
Position III : high power heating (2400 W)
- The operating light indicator lights when the appliance is in use.
- To switch off the appliance, turn the power mode selector on O position.

TEMPERATURE SETTING :

- Set the thermostat to maximum position. The light indicator comes on.
- When the room is at the required temperature, slowly turn the thermostat anticlockwise until the
fan goes off. The appliance will now switch on and off automatically to keep the room at the desired
temperature.
- For antifrozen function, set power I or II and turn the thermostat to min to put
mark. When room temperature goes down 4°C, the appliance will automatically starts in order to keep
this temperature.
AUTOMATIC CUT-OFF :
This appliance is equipped with an automatic cut-off device in case of overheating or fall.
- Switch off and unplug the appliance.
- The dust may be removed with a soft cloth or a vacuum cleaner.
- Clean the body with a soft, dry cloth (never immerse appliance in water), do not allow water to run
into the interior of the heater.
- When the heater is not used for a long time, protect it from dust and dry.
9/04/09 11:18 Page 4
USING
CLEANING
7
A
in front of the visual