Mode Setting; Temperature Setting - ALPATEC MSBT 20 Notice D'utilisation

notice MSB 20:notice RC_20ET

MODE SETTING :

- Turn the power mode selector(1) into position :
: Fan function
1: low power heating (1000 W)
2: high power heating (2000 W)
- The operating light indicator (3) lights on when the appliance is in use.
- To switch off the appliance, turn the power mode selector on O position.

TEMPERATURE SETTING :

- Set the thermostat (2) to maximum position. The light indicator (3) lights on.
- When the room is at the required temperature, slowly turn the thermostat anticlockwise until the fan
goes off. The appliance will now switch on and off automatically to keep the room at the desired
temperature.
AUTOMATIC CUT-OFF :
This appliance is equipped with an automatic cut-off device in case of overheating.
- Switch off the appliance and cut the power off.
- Clean the body with a soft, dry cloth (never immerse appliance in water), do not allow water to run
into the interior of the heater.
- The dust may be removed with a soft cloth or a vacuum cleaner.
- When the heater is not used for a long time, protect it from dust and dry.
19/05/10 10:40 Page 11
USING
CLEANING
11