Thermostat Setting - ALPATEC RSE 2400 Mode D'emploi

All manuals and user guides at all-guides.com
RSE 2400 notice:Notice RSB 2005
Select the desired temperature by turning thermostat knob : 5°C to 35°C. It is display on the screen. Select 5°C
for antifrozen mode.
After few seconds, the control panel displays the room temperature.
The appliance is equipped with a timer from 30 min. to 24h.
The appliance stops automatically at the end of setting time.
To activate the timer, press " " knob (2) until the desired time appears on display (step of 30 min.).
The time picto flicks on display during the setting time and became fix after. The control panel displays the
remaining time.
To cancel the timer, press " " knob (2) until "0:00" appears on display.
SAFETY CUT-OFF WHEN OVERHEATING
SAFETY CUT-OFF WHEN OVERHEATING
This appliance is equipped with an automatic cut-off device in case of overheating. This device allows to
stop the appliance when the heat inside the appliance's body becomes too high.
This cut-off stops the heating element.
If the appliances stops, ensure you that the opening does not be obstructed.
Before cleaning, ensure that the appliance is switched off and unplugged.
Clean the outside with a dry cloth.
From time to time, clean the inside with a vacuum cleaner on a low setting.
After each season's use, we suggest that the appliance be cleaned with a cloth.
18/09/07 15:06 Page 7

THERMOSTAT SETTING

THERMOSTAT SETTING
TIMER
TIMER
CLEANING
CLEANING
7