TREND NETWORKS SignalTEK 10G Guide D'utilisation page 18

Network Test - PING4 and PING6
EN
1. Connect the display unit to the network under test
Set the link speed to Auto in the display unit via
2.
RJ45 - Link Speed
Set the IP address to Dynamic (DHCP) via Settings - Network - IPv4 - IP
3.
Assignment
4. After the unit link up and acquired IP address, the tester is ready to setup
5. Set up number of PING running, Pause time, packet size and Target URL
6. Press Test key to run the test
7. To check PING result detail, click the destination URL to have more
detailed info. Repeat procedure for PING 6 Test
8. Save the results
1
4
18
www.trend-networks.com
2
5
Settings - Network -
3
6