TREND NETWORKS SignalTEK 10G Guide D'utilisation page 17

Transmission - CCTV Data Test
1. Connect both display and remote units to the network or cable under test
2. Pair the remote unit with the display unit via
status connection will light up blue once successfully paired
Set the link speed to Auto in the display unit via Settings - Network -
3.
RJ45 - Link Speed
4. Set up No. of Cameras, Resolution, codec, frame loss type & Limit and test
duration in CCTV Data settings
5. Press Test key to run the test
6. Packet loss and jitter/delay info will be presented
7. Save the results
1
4
2
5
Settings - Pairing. The
3
6
Depend On Us
EN
17