Beamz DMX-512MINI Manuel D'instructions page 8

PROGRAMMING
Press "Menu" button, display shows "C-xx"
When display from "C-01 ~ C-30", press "UP" "DOWN" to select the scene which must be created and press and hold
"ENTER", then press "UP" or "DOWN" button to enter programming. It will now automatically enter the menu selection.
When display shows "PA-1", a dot on the LED panel will flash. Select the channel block (PA-1 to PA-8) to program the
correct channel. When in programming state you can adjust the channel value according to above instructions. Press
"ENTER" ±2 seconds to save. When display shows "SAVE" it means save is successfully, and unit goes automatically
enter into "C-xx" to run the data just saved. During programming, you can each channel (1-512) setting to the correct value
and then save the whole scene. NOTE: You can save only when the dot in the LED panel is flashing.
CALLING PROGRAMM
Press "Menu" button, display shows "C-xx"
If display shows "C-OF" it means DMX fader control mode. If display shows "C-01" it means select the dimming value of
scene 1. Controller will transfer the previous saved 512 dimming value to be DMX signal and send to device which was
controlled. With the "UP" "DOWN" button you can select the next or previous stored scene (30 total).
When calling the saved dimming value, the 8 indicators under the faders will go ON and OFF. The 8 faders don't work
under this mode. NOTE: It's only possible to select one scene at the same time and it is not possible to play back all
scenes in a automatically modes.
Display the channel value of fader
When display shows "PA-1" press "MENU" button 3 times. The LED panel will now display the value of the channel.
In this menu the first LED digit flashes to display channel, other 3 digits display the value of this channel.
Press "MENU" to return to the menu.
Reset (Clear all memory data)
When controller is off, simultaneously press "MENU" and "ENTER" button and switch the unit "ON" to enter the reset meu.
Display shows "LOAD". Press "ENTER" to clear and it will be switched on automatically.
If you don't want to clear, press "MENU" to exit.
NOTES:
1. When setting to run the preset programms, select "C-02" and it will run the same mode by next switch "ON". Fader is
invalid at this moment. Please select "C-OF" if you need to change to manual control mode. Press "ENTER" to save.
2. You must turn the power switch to "OFF" when not using the unit. You can't only disconnect the plug, otherwise the
battery will not stop powering the unit and it will empty.
3. When battery power is not enough, it will automatically restart several times and finally have no display. The 12V
adapter should be used for powering the unit. It will charge the battery too. Full charge should be no less than 8 hours.
4. The controller has energie saving function. When it's not operated for 1 minute the LED panel will go off and just display
a flashing dot.
6