Eliminating Minor Faults Yourself - Bosch KDN Serie Notice D'utilisation

Eliminating minor faults yourself

Before you call customer service:
Please check whether you can eliminate the fault yourself based on the following
information.
Customer service will charge you for advice – even if the appliance is still under
guarantee!
Fault
Temperature differs greatly
from the set value.
It is too cold in the
refrigerator section or in the
chill compartment.
The temperature in the
freezer section is too warm.
Appliance is not cooling,
temperature display and light
are lit up.
The side panels of the
appliance are warm.
All manuals and user guides at all-guides.com
Possible cause
Appliance opened
frequently.
The ventilation openings
have been covered.
Large quantities of fresh
food are being frozen.
Showroom mode is switched
on.
Pipes run into the side panels
which heat during the
cooling process.
Remedial action
In some cases it is adequate to switch off
the appliance for 5 minutes.
If the temperature is too high wait a few hours
and check whether the temperature has
approached the set value.
If the temperature is too low check
the temperature again the next day.
Increase the temperature in the refrigerator
section.
Push temperature controller for the chill
compartment downwards. Fig. )
Do not open the appliance unnecessarily.
Remove obstructions.
Do not exceed the freezing capacity.
Press and hold freezer/fridge button for
15 seconds.
"77" appears briefly on the control panel.
After a short time check whether your
appliance is cooling.
That is normal behaviour for the appliance and
not a fault.
Furniture touching the appliance will not be
damaged by the heat.
en
21