Pioneer SC-LX83 Guide Rapide page 9

Before you start
The remote has been conveniently color-coded according
to component control using the following system:
• White – Receiver control, TV control
• Blue – Other controls (see the Operating Instructions
in CD-ROM for detail)
1 MULTI-ZONE operation selector switch
Switch to perform operations in the main zone, ZONE 2
and ZONE 3.
 RECEIVER
2
This switches between standby and on for this receiver.
3 MULTI OPERATION
Use this button to perform multi operations.
4 Input function buttons
Press to select control of other components. There is no
AUX input on this receiver, so the AUX button cannot be
used.
5 INPUT SELECT
Use to select the input function.
6 Character display
This display shows information when transmitting
control signals. The remote screen's display differs when
operating the receiver by sending infrared signals from
the remote control and when operating it by RF two-way
communications. For details, see Remote control display
on page 10.
7 TV CONTROL buttons
These buttons are dedicated to control the TV assigned to
the TV operation selector switch.
8 Receiver setting buttons
Set the remote control operation selector switch to
RECEIVER first to access:
AUDIO PARAMETER – Use to access the Audio
options.
VIDEO PARAMETER – Use to access the Video
options.
HOME MENU – Use to access the Home Menu.
RETURN – Press to confirm and exit the current
menu screen.
////ENTER
9
Use the arrow buttons when setting up your surround
sound system and the Audio or Video options.
10 Receiver Control buttons
Set the remote control operation selector switch to
RECEIVER first to access:
STATUS – Press to check selected receiver settings.
Note
1 Press and hold in the LIGHT button for 5 seconds to change the illumination mode 1 or 2. When set to LIGHT MODE 2 (default), the
illumination only lights when the remote control LIGHT button is pressed. When switched to LIGHT MODE 1, the illumination lights whenever
buttons are operated. Setting LIGHT MODE 1 will shorten the service life of the batteries.
PHASE CTRL – Press to switch on/off Phase Control
or Full Band Phase Control.
CH LEVEL – Press repeatedly to select a channel,
then use / to adjust the level.
THX – Press to select a Home THX listening mode.
PQLS – Press to select the PQLS setting.
AUTO/ALC/DIRECT – Switches between Auto
Surround (page 34), Auto Level Control, Optimum
Surround mode and Stream Direct mode (page 34).
STEREO – Switches between stereo playback and
Front Stage Surround Advance modes.
STANDARD – Press for Standard decoding and to
switch various modes (2 Pro Logic, Neo:6, etc.)
(page 33).
ADV SURR – Use to switch between the various
surround modes (page 34).
SIGNAL SEL – Use to select an input signal.
SLEEP – Use to put the receiver in sleep mode and
select the amount of time before sleep.
DIMMER – Dims or brightens the display.
A.ATT – Attenuates (lowers) the level of an analog
input signal to prevent distortion.
SBch – With this receiver, SBch cannot be used.
MCACC – Press to switch between MCACC presets.
HDMI OUT – Switch the HDMI output terminal.
11 LIGHT
Press to turn on/off the illumination for the buttons.
12 Remote control operation selector switch
Set to RECEIVER to operate the receiver, TV or SOURCE
to operate the TV or the source device.
When this switch is set to RECEIVER, the receiver can be
controlled (used to select the white commands). Also use
this switch to set up surround sound.
13 VOL +/–
Use to set the listening volume.
14 MUTE
Mutes the sound or restores the sound if it has been
muted (adjusting the volume also restores the sound).
01
1
9
En