PLAYTIVE JUNIOR 307527 Notice D'utilisation page 8

• The child must always wear a helmet and
sturdy shoes when driving the product! We
also recommend the use of suitable protective
equipment.
• Always show consideration for other people!
• Only use the product on suitable surfaces that
are level, clean, and dry. Drive away from other
road users where possible.
• The product may not be used on slopes or close
to steps or open water! Avoid dangerous areas!
• The product may not be used in the dark or in
bad visibility conditions!
• Do not allow your child to use the product wit-
hout supervision because children are not able
to assess potential risks.
• Please take into account that children are often
not able to correctly assess their own ability or
certain dangerous situations! Children's need to
play often creates unforeseen situations that are
not the responsibility of the supplier/manufactu-
res.
• Instruct the child on the correct handling of the
product and point out potential risks!
• Dexterity is required for the use of the product
in order to avoid falls or collisions that could
lead to the injury of the driver or other persons.
• Do not connect the product to other vehicles,
pieces of sports equipment, or other pulling
devices. The product is not designed for higher
speeds.
• Maximum load-bearing capacity of the pro-
duct: 45kg.
• No technical modifications may be made to the
product.
Avoiding damage to property!
• Avoid water, oil, potholes, and very rough
surfaces.
Assembly
Note: Two people are needed to assemble the
product.
1. Mount the front axle on the frame
(figure B)
Push the cover (11) onto the front axle (2).
Attach the frame (1). Secure the frame using
the screw (17).
10 GB/IE
All manuals and user guides at all-guides.com
2. Assemble the steering rod
(figure C)
Remove the pre-assembled screw (3a) and the
washer (3b) on the steering rod (3). Attach the
steering wheel (5) to the steering rod with the
washer and the screw. Place the cover (16) into
the steering wheel.
3. Mount the steering rod (figure D)
Slide the cladding (12) onto the steering rod.
Slide the steering rod onto the front axle and at-
tach the steering rod at a suitable height using
the bracket (2a).
4. Assemble the front cladding and
the tachometer display (figure E)
Mount the front cladding (8) to the steering
rod. Attach the cladding on the top back using
the tachometer display (9) and two screws (21)
and at the bottom using the mounting bracket
(13) and four screws (21).
5. Mount the front wheels
(figure F – view from the front)
Attention: please note the direction of
movement of the wheels.
Remove the pre-assembled screws (2c) and
washers (2b) on the front wheel axle. Place
one right wheel (6) and one left wheel (7) onto
the front axle and secure them with the washers
and screws. Attach a protective cap (15) to
each wheel.
6. Mount the rear wheel axle
(figure G)
Remove the pre-assembled mounting material
on the rear wheel axle (4). Attach a cover (14)
to the rear wheel axle. Slide the rear wheel
axle onto the frame. Secure the rear wheel ax-
les using the screws (18a) and nuts (18b). Slide
the second cover onto the rear wheel axle and
position it close to the frame.
7. Mount the rear wheels
(figure H – view from behind)
Attention: please note the direction of
movement of the wheels.
Place one wheel each (6) and (7) on the rear
axle and attach it using the assembly material
that was removed previously (4a - 4c).
Place a protective cap (15) on each wheel.