Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
DESCRIPTION
The models of the "OPERA D" series use cutting edge digital amplifiers of the DIGIPRO
series, providing three different powers - 200W, 400W, and 600W - to meet the
requirements of any kind of application.
These highly efficient amplifiers provide high power with limited weight and dimension.
Thanks to the low power dissipated, the cooling of the amplifier module does not require a
fan.
The digital preamplifier with DSP (Digital Signal Processing) controls the audio crossover
of the acoustic components, the frequency response, the limiter, and the phase
alignment. A selector enables to select one of two different equalizations - "FLAT" or
"PROCESSED" - to provide high versatility for the different applications.
The amplifiers DIGIPRO 400W e 600W use power supplies featuring SMPS (Switched-
®
Mode Power Supplies) technology.
This technology increases power supply efficiency and minimizes its weight.
The correct operation is signalled by the lighting of a blue indicator, located on the front
panel of the speaker. The indicator can be disabled following a specific procedure
described in paragraph "Front LED" (Page 20).
OPERA 208D
The OPERA 208D bi-amped active speaker is
®
equipped with a DIGIPRO amplifier delivering 150W
RMS for the bass section and 50W RMS for the high
frequency section.
The 2-way bi-amplified speaker is equipped with 8"
woofer (1,5" voice coil) and 1" Neodymium driver (1"
voice coil) loaded with 80°/65°x60° asymmetric horn.
The speaker is in plastic material, provided with
recessed top handle, easing its transport.
In the bottom of the box there is a standard pole mount
cup (D36mm).
The speaker has been designed to be used also as
stage monitor (43° angle).
REFLEX HOLES
DRIVER
INDICATOR
LIGHT
WOOFER
15
REFLEX HOLES
O
O
P
P
E A
E A
R
R
D D
HANDLE
AMPLIFIER
OPERA
D
43° PLANE
43° PLANE
d
B
TECHNOLOGIES
I I
Æ 36mm PEDESTAL/BRACKET
HOUSING
OPERA 210D
®
The OPERA 210D bi-amped active speaker is
equipped with a DIGIPRO amplifier delivering 150W
RMS for the bass section and 50W RMS for the high
frequency section.
The 2-way bi-amplified speaker is equipped with 10"
woofer (1,5" voice coil) and 1" Neodymium driver (1"
voice coil) loaded with 80°/65°x60°asymmetric horn.
The speaker is plastic material and is provided with
top handle, rubber coated , easing its transport
In the bottom of the box there is a standard pole mount
cup (D36mm).
The speaker has been designed to be used also as
stage monitor (43° angle).
OPERA 410D
The OPERA 410D bi-amped active speaker is
equipped with a DIGIPRO amplifier delivering 300W
RMS for the bass section and 100W RMS for the high
frequency section.
The 2-way bi-amplified speaker is equipped with 10"
woofer (2" voice coil) and 1" compression driver (1.3"
voice coil) loaded with 80°/65°x60° asymmetric horn.
The speaker is plastic material and is provided with
top handle, rubber coated , easing its transport
In the bottom of the box there is a standard pole mount
cup (D36mm).
The speaker has been designed to be used also as
stage monitor (43° angle).
REFLEX HOLES
DRIVER
INDICATOR
LIGHT
WOOFER
REFLEX HOLES
®
OP ER
OP ER
A
A
D D
®
HANDLE
AMPLIFIER
OPERA
D
43° PLANE
B
d
TECHNOLOGIES
I I
Æ 36mm PEDESTAL/BRACKET
HOUSING
43° PLANE
16
Publicité
Table des Matières
