Publicité
Les langues disponibles
Les langues disponibles
3. The status LED lights up blue and you will hear a short
beep as soon as the loudspeaker is connected to your
de-vice.
NOTE:
• The loudspeaker should be no further than within a
radius of 10 m around your device.
• If the speaker is on, it will automatically connect to the
last connected device, if available. If not, the speaker
switches to pairing mode. (The speaker can store a
maximum of 8 already connected devices)
• The speaker turns off automatically after 10 minutes if it
is not connected to a device during this time.
Disconnecting Bluetooth® connection manually
(uncoupling)
Press and hold the Volume Plus and Volume Minus buttons
for 1 second until the LED status light quickly flashes
blueagain. You will hear a short beep. The speaker is then
discon-nected from your Bluetooth® device and in pairing
mode again.
Switching the light band on/off
To switch on the light band, which connects both
loudspeakers, press the light button 1x. The light band
then lights up permanently. By another click on the light
button, the light band begins to light up alternately and
pulsatingly and the light is no longer permanently on. By
another click on the light button you switch off the light
strip again, where-upon it no longer lights up.
Connection via AUX input
1. Turn on the speaker as described above.
2. Use the supplied 3.5 mm jack cable to connect your
external device to the AUX-In connector of the speaker.
3. The speaker will automatically switch to AUX-In mode
and the Status LED light will turn steady green.
Publicité
