Safety Instructions - Inakustik REFERENZ AC-3500P Mode D'emploi

OPER ATION MANUAL REFERENZ AC-350 0P

SAFETY INSTRUCTIONS

GENERAL
Thank you for using the AC-3500P. Please read, observe and adhere to the following safety instructions. Please keep the operating manual.
Observe all the warning notices on the components and in the operating manual.
PROPER USE
The device is designed solely for operation on audio and video equipment in private environments and solely for indoor use.
Connect it as specified in the operating instructions. Also observe the operating instructions of the devices to be connected.
Only use accessories which have been recommended by the manufacturer.
The device may only be operated in the specified voltage range!
SAFETY INSTRUCTIONS
Do not expose the device to high levels of humidity under any circumstances. Select an installation location for the device which does not have
a high level of relative humidity and is free of moisture. Moisture can bypass the electrical insulation and pose a lethal danger.
Do not position the equipment near sources of heat, heaters, ovens or other heat-producing devices. Note that electric devices may heat up
during operation.
Extreme temperature fluctuations, humidity and extended exposure to light can damage the cable and alter their appearance. Make sure that
no foreign objects or liquids enter the device.
Make sure that the rack or board can safely support the weight of the device.
All cables must be placed in such a way that there is no danger to damage them (e.g. being stepped on, sharp edges etc.). The cable must not
be bended, pulled or twisted. Never remove cables by pulling the cable; instead, always hold the plug when disconnecting.
Pay attention to the accuracy and correct fit of the plugs or connectors. Do not use high force to plug the connectors into the device sockets.
MAINTENANCE
Maintenance on the product may only be performed by persons qualified to do so. Maintenance is necessary in all cases of damage, i.e. in the
case of damaged cables and plugs, as well as after liquid spills or objects falling on the device, devices falling down, foreign objects entering
the device, exposure of device to rain or humidity, or other influences impairing the functioning of the component.
LOOKING AFTER THE PRODUCT
Disconnect the components from the power supply before cleaning them Always clean the components with a soft, dry and lint-free cloth, or
with a brush. Do not under any circumstances use scouring powder, alcohol, benzine, furniture polish or similar substances.
5