Cleaning And Care - Westinghouse WSHPTCBN1901 Manuel D'instructions

9. To turn the heater off, press the ON/OFF button (10), the fan
will run for 14 seconds to cool the heater and then the screen
will turn off. Press the POWER switch (2) to the off position O.
10. Unplug the heater from the mains power supply when it is not
in use.
NOTE:
• Do not cover the heater or the air outlets/vents at any time
while it is turned on. There is a risk of fire if the heater is
covered.
• For safety reasons, this heater is equipped with a tip-over
sensor. This sensor automatically shuts down the heater if it is
not in an upright position while in operation. To resume normal
operation, check the heater is cool enough to handle, turn it
upright and turn it on again.
• The heater has a built-in overheating protection mechanism.
The safety mechanism will turn off the power if the heater
overheats. Press the ON/OFF button (10) to turn the heater off
and pull the mains plug from the socket. Wait for 10 minutes
for the heater to cool down. Remove the cause of overheating
i.e. excessive dust and turn on the heater. If for any reason the
heater does not turn on, take it to your local service center for
repair.
• The heater is designed to be used at temperatures above
-20°C. If it is exposed to temperatures below this, allow it warm
up to this temperature before turning it on.
CAUTION: Always unplug the appliance from the mains
1.
power supply and let it cool down before cleaning.
2. Wipe the outside of the heater and remote control with a soft,
damp cloth and dry thoroughly. Do not let any liquid enter the
heater or the remote control.
3. Remove the air inlet filter by lifting up the tabs at the bottom
of the filter and pulling it away from the appliance. Clean
under running water. Dry thoroughly before reassembling the
EN
appliance.
12
HOW TO USE

CLEANING AND CARE