Publicité
Les langues disponibles
Les langues disponibles
•
Never attempt to remove or replace any parts other than
those specified in this manual.
Additional safety instructions for Food
Mixers
Warning! Do not place near a hot Gas or electric oven.
•
Do not Immerse Mixer, Base, Cord or Plug in any liquid.
•
Allow all moving parts of the appliance to come to a stop
before approaching.
•
Always use on a clean work surface and clean the
surface thoroughly after use.
•
Allow the appliance to cool before storing.
•
Keep hands, long hair and loose clothing away from the
beaters.
•
Always take care when handling the sharp cutting
blades when emptying the bowl and during cleaning.
•
Be careful if hot liquid is poured into the blender as it
can be ejected out of the appliance due to a sudden
steaming.
Electrical safety
This tool is double insulated; therefore no earth
wire is required. Always check that the power
supply corresponds to the voltage on the rating
plate.
•
If the supply cord is damaged, it must be replaced by the
manufacturer or an authorised BLACK+DECKER
Service Centre in order to avoid a hazard.
Using an extension cable
•
Always use an approved extension cable suitable for the
power input of this tool (see technical data). Before use,
inspect the extension cable for signs of damage, wear
and ageing. Replace the extension cable if damaged or
defective. When using a cable reel, always unwind the
cable completely.
Features
1. Bowl cover
2. Stainless steel bowl
3. Multifunction head
4. Release button
5. Speed control switch
6. Mixer blade
7. Dough hook
8. Whisk
(Original instructions)
Assembly
Warning! Before performing any assembly or
maintenance, switch off and remove from power
supply.
Use
Warning! Let the appliance work at its own pace. Do not
overload.
•
Clean the beaters, dough hook, whisk and bowl before
use.
•
Place the appliance on a flat, steady surface.
•
Ensure that the power cord is unplugged from the power
outlet and the speed selector (5) is set to the "0" position.
•
Lift the release button (4) & raise the multi function head
until it locks in place (Fig. A).
•
Push the whisk (8), dough hook (7) or mixer blade (6)
onto the Mixer drive shaft and rotate it clockwise to lock it
in place (Fig. A).
•
Beaters are for mixing egg white or other liquid, dough
hooks are for kneading dough, whisk is for Light mixtures
e.g. Cream, eggwhites, blancmange etc.
•
Add the ingredients to the bowl.
•
Lower the release button (4) and lower the multi function
head until it locks in place.
•
Attach the bowl cover (1) (Fig. B)
•
Attach the bowl cover access slot (1a). You can use this
to add further ingredients to the bowl while the appliance
is in operation.
•
Connect the unit to a suitable supply.
•
Rotate the rotary speed control switch (5) to the required
setting.
•
Once mixing is completed, return the speed control (5) to
the "OFF" position and disconnect the appliance from the
electrical supply.
•
Press the release button (4) and raise the motor housing
until it locks in place.
•
Remove the mixing attachment by pushing it up and
rotating it anti-clockwise.
•
Remove the bowl (2) by rotating it anti-clockwise and
lifting it from the stand.
Warning! Do not place knives, spoons, forks or any other
object into the bowl while operating.
Note! The maximum operation time must not exceed 10
minutes. After 10 minutes of use allow the mixer to rest and
cool for an appropriate amount of time.
•
When Kneading dough, best results can be achieved by
setting the speed selector at a low speed first and then
high speed.
ENGLISH
5
Publicité
