Publicité
Les langues disponibles
Les langues disponibles
If you are using a standard DMX controller, you can connect the DMX output of the controller directly to the DMX input of the first unit in a DMX chain.
Always connect the output of one unit with the input of the next unit until all units are connected.
At the last unit, you must close the DMX line with a terminating resistor. Take an XLR connector and solder a 120 Ohm resistor
between signal (-) and signal (+) and connect it to the DMX output of the last unit in the line.
1
Snow
2
Fan
We recommend a frequent cleaning of the unit, in particular the output nozzle.
There are no serviceable parts inside the unit except for the fuse. Repairs and service operations are only to be carried out by authorized
dealers.
Disconnect from mains before starting maintenance operation!
•
Ensure the fluid do not become contaminated.
•
Ensure the air vents are not clogged by dust. If necessary remove the dust.
•
Ensure that the unit can not get overheated.
•
Do not run the unit without any fluid, as the pump will run dry.
Wipe up spilled fluid immediately. Moisture and fluid can permanently damage the electrical components of the unit.
•
•
For cleaning the surface of the unit use a suitable, solvent-free cleaner.
•
It is recommended to run the unit on a monthly basis in order to achieve best performance and output condition.
•
Before storing, run distilled water through the system. This will help clean out the remaining snow fluid and prevent pump from malfunction on
next usage.
If the fuse is defective, replace the fuse with a fuse of the same type and value. Before replacing the fuse, unplug mains lead.
000-001
No function
002-255
Snow output from 0-100%
000-255
Fan output level 0-100%
Procedure:
Step 1: Open the fuse holder on the rear panel with a fitting screwdriver.
Step 2: Remove the old fuse from the fuse holder.
Step 3: Install the new fuse in the fuse holder.
Step 4: Replace the fuse holder in the housing.
Publicité
