Publicité
Les langues disponibles
Les langues disponibles
c) Mounting the support arm and the reflector
Mount the support arm on the mast as shown in the
drawing
In doing so, tighten the wing-nuts on the mast clamp
only slightly until the bracket holds securely for the
further mounting on the mast.
Then lower the reflector into the pre-positioned
securing screws.
Tighten the securing screws only slightly at first by
holding the short end of the hexagon spanner until the
screws are hand-tight.
Now turn the hexagon spanner around. If you now
give the screws an extra one-quarter of a turn using
the long end of the spanner they are fully tightened. If
you should happen to have a torque wrench available,
tighten the screws to about 4-5 Nm.
Only tighten sightly
First tighten slightly...
...then effect 1/4 of a turn to
screw down
Publicité
