Warnings and Recommendations
WARNING:
WARNING:
WARNING:
WARNING:
WARNING:
WARNING:
RF SAFETY WARNING: Any antenna used with this device must be located at least
This is a CONSUMER device.
BEFORE USE, you MUST REGISTER THIS DEVICE with your wireless provider and
have your provider's consent. Most wireless providers consent to the use of signal
boosters. Some providers may not consent to the use of this device on their network. If
you are unsure, contact your provider.
In Canada, BEFORE USE you must meet all requirements set out in ISED CPC-2-1-05.
You MUST operate this device with approved antennas and cables as specifi ed by the
manufacturer. Antennas MUST be installed at least 20 cm (8 inches) from (i.e., MUST
NOT be installed within 20 cm of) any person.
You MUST cease operating this device immediately if requested by the FCC (or ISED in
Canada) or licensed wireless service provider.
WARNING. E911 location information may not be provided or may be inaccurate for calls
served by using this device.
This device may be operated ONLY in a fi xed location (i.e..may operate in a fi xed loca-
tion only) for in-building use.
13
Contact Wilson Electronics Customer Support Team with any questions at
To uphold compliance with network protection standards, all active
cellular devices must maintain at least 6 feet of separation distance
from Panel and Dome antennas.
Connecting the Signal Booster directly to the cell phone with use of an
adapter will damage the cell phone.
Use only the power supply provided in this package. Use of a non-
Wilson Electronics product may damage your equipment.
The Signal Booster unit is designed for use in an indoor, temperature-
controlled environment (less than 150 degrees Fahrenheit). It is not
intended for use in attics or similar locations subject to temperatures
in excess of that range.
Warning: The Outside Antenna must be installed no higher than 10
meters (32'9") above ground.
Take care to ensure that neither you nor the pole comes near any
power lines during installation.
8 inches from all persons.
866-294-1660 or email: tech@wilsonelectronics.com