Sony DVCAM SDTI-CP DSBK-210 Manuel D'installation page 17

Additional Menu Items
When this board is installed in the DSR-2000/2000P, the
following additional items appear in the setup menus.
For details of how to use the menus, refer to the Operating
Instructions for the DSR-2000/2000P.
In the table, the settings enclosed in a box are the factory
default values.
Item number Item name
017 SUB STATUS
DMC/FEED PLAY
111
914
SDTI-CP OUTPUT
BIT RATE
915 SDTI-CP OUTPUT
FORWARD ERROR
CORRECTION
Settings
Select supplementary status information to be
displayed as superimposed text information on
the monitor screen.
OFF : No "sub" information
TC MODE: Operating status of internal time
code generator
AUDIO MIX MODE: Mixing status of audio input
signals
TAPE REMAIN: Remaining tape
CP OUT BIT RATE: Bit rate selected by menu
item 914
Select the function of the DMC EDIT button as
DMC mode or feed mode.
DMC : Enable DMC playback or DMC editing.
FEED: Enable feed playback or auto feed
playback.
For details of feed playback and auto feed
playback, see the section "Feed Playback
Operations" on the next page.
Set the bit rate for MPEG2-encoded output.
50Mbps I-Only
40Mbps I-Only
30Mbps I-Only
Select whether or not to add error correcting
codes (FEC: Forward Error Correction) to
protect against transmission errors on the SDTI-
CP output signal.
ON : Add FEC.
OFF: Do not add FEC.
17