Proline THEOB Manuel D'utilisation page 7

OPERATION
Before first use, it is recommended to operate the kettle for 2 to 3 times
following the instructions below. This will remove any dust or residues
remaining from the manufacturing process.
1. Place the power base on a dry, flat and stable surface.
2. Open the lid by pressing the lid release button and then lifting the lid
upwards.
3. Fill kettle with desired amount of cold water.
• Always fill the kettle between the minimum and maximum marks on
the water level window.
4. Close the lid by pressing it down until it clicks into place.
5. Place the kettle on the power base and insert the plug into the mains
socket.
6. Press the power switch. The water is being heated.
• The indicator light inside the kettle will illuminate.
7. The kettle will switch off automatically when the water has boiled.
• The indicator light will go out.
• You can stop the boiling process by setting the power switch to the 0
(Off) position.
8. Lift the kettle from the power base and then slowly pour the boiling
water.
NOTE: Use the kettle only when the lid is closed and the filter is in place.
Cut-out for boil-dry protection
If you operate the kettle without water, the kettle will stop heating and
automatically switch off.
If this occurs, allow the kettle to cool before filling with cold water and re-
boiling.
EN-5
EN